You are currently viewing How to Make Car Speakers Louder Without Amp?

How to Make Car Speakers Louder Without Amp?

There is always room for improvement in any audio device. But the question is how to make the speaker louder without an amplifier.

If the sound quality of your speakers is moderate, you should check the highest sound settings. There are also inexpensive ways to improve your car’s speakers.

Best ways to make Car Speakers louder without an amplifier

Not every car has the best sound system in the world, but that doesn’t mean you have to put up with it or spend a lot of money. If you want to make your car speakers louder without an amplifier, you can try a few tips:

1. Check for proper sealing of car door speakers

Another way to improve the volume of car speakers is proper sealing. Sealing car speakers to a door or enclosure is one of the simplest and least expensive ways.

To seal the speaker, we use gasket tape, which is nothing more than a thin foam with an adhesive layer on one side.

To use it, you will need to tape around the speaker mounting holes on the door panel or the adapter ring, depending on what element the speaker is installed on.

When the foam around the mounting holes is completely covered, you can screw the speakers into place. Foam seals the speaker to the door panel much better.

The speaker is sealed to isolate the front sound waves from the sound waves behind the speaker.

Separating the waves reduces sound distortion or cancellation, which is very important when you want your speakers to work properly.

Seal the speaker to prevent air from entering the front of the rear.

When mounted, all speakers must have proper sealing, but this is especially important with subwoofers that produce huge sound waves.

When you put your hand around the subwoofer playing, you can feel air blowing under the speakers.

In that case, the subwoofer is not sealed properly, and the bass performance is limited.

It’s a good way to check the quality of your subwoofer before buying.

If you feel the air around your speakers or hear sounds that aren’t part of the music, check the other boxes or ask for a discount and add gasket tape at home.

2. Add a subwoofer

Adding a subwoofer is important and should be considered as the subwoofer also acts as a speaker system.

A subwoofer is an important source of enhancing the effectiveness of any speaker system. The speaker should be placed in the corner of the vehicle where vibration does not occur.

You should also adjust the phase of your subwoofer for optimum effect.

A device capable of generating maximum bass for maximum sound output. Here are some amazing subwoofers you can consider.

3. Adjust settings via equalizer

Due to the building materials of the car, it isn’t easy to achieve high sound quality even with everything. A typical automobile consists of a metal surface that reflects sound waves and a soft surface that absorbs sound, such as a seat cover.

Don’t forget the speaker placement. All of these factors cause sound misalignment that doesn’t feel right. Also, some frequencies rise, causing fatigue in the long run.

To solve these problems, you need an equalizer that fine-tunes the frequencies your speakers produce and tries different EQ curves depending on your preference.

4. Add Twitter

Adding a tweeter is another great way to boost the volume of your car speakers.

A tweeter can produce a decent sound frequency and maximum bass level by making the peaks sound nicer and more amazing.

It will also produce a higher and clearer bass effect.

5. Correct cabling and connectors

After a while, your car’s wireless cable may wear out and need to be replaced with a new one. Sometimes this cannot be easy.

However, sound lovers should be aware that cables will need to be replaced after a significant period. This will prevent the music from constantly interrupting.

Replacing the cables will give you the perfect bass without affecting the sound and volume of your car speakers.

6. Replace old wires

Often we drive our vehicles on bumpy roads. Besides making travel uncomfortable, these crashes can also loosen the audio connection inside the car.

However, your wires can wear out over time with continued use, even if you don’t have this problem.

Aging wires can reduce signal strength, producing a weaker, lower-volume sound from the speaker.

If you’ve tried everything else and haven’t improved, it might be a frontline that needs to be updated.

7. Use of capacitors

Capacitors can control energy dissipation during music playback. This can cause a full bass in the car.

As with playing louder music with full bass, the quality of the audio system is often affected.

Adding capacitors gives you the freedom to hear louder sounds without damaging your music system.

8. Gadgets

Numerous devices and add-ons can be included to enhance the volume of car speakers without an amplifier.

These gadgets and add-ons allow you to control and adjust speaker levels to create great sound.

Gadgets to add include an equalizer or Bluetooth/wireless audio system.

9. New cable

If you overlook the condition of your wires and cables, you make a big mistake.

Using cheap, crude, and small cables will affect the power flow from the head unit to the speaker.

If the speaker is not receiving adequate output, it will produce a weak, distorted sound.

Over time, the speaker may be damaged.

Cables are susceptible to normal wear and tear. The sound system needs to be replaced repeatedly to keep it running smoothly.

Invest in a quality cable, and you will hear the difference in sound quality.

How to add a subwoofer without an amplifier?

Disconnect the car battery before starting.

Carefully remove the current vehicle speakers from the mounting dock, as you will need access to the wiring.

Choose an appropriate location for your subwoofer.

Route the power supply and stereo cables to this location.

Connect and mount the subwoofer. If your car’s sound system has a subwoofer outlet, you must also connect that outlet.

Frequently Asked Questions

Can I upgrade my car speakers without an amplifier?

Amplifiers are the most common way to improve a car’s sound system, but it is possible to upgrade car speakers without an amplifier.

It can be a little complicated if you’re a beginner, but you can ask someone who knows a lot about sound systems for help.

You can upgrade by replacing your car speakers or adding a subwoofer to improve sound quality.

How to make old car speakers loud with voice coil wire?

Add tweeters to boost vocals and sharper music to make old car speakers louder with voice coil wire.

These tips will help you get the right sound from your car speakers. However, you may consider installing a sound system if you are still unsatisfied.


These methods of making the speaker louder will work in any car in 2022. However, to achieve the best audible improvement, you need to make some changes together, and you won’t regret it.

Gabriel Dani

Gabriel Dani is an experienced writer who gives his opinions on Car's speaker. Gabriel began collecting the best audio product listings, buyer guides, how to use, fix, and more. His goal is to give people easy access to quality information about car speakers so they don't have to spend time researching.

Leave a Reply